Bear Print Sleepsuit Fits Jellycat Plush

A cream all-in-one with feet, printed with small brown bears and closed with a row of buttons down the front. The collar is a separate scalloped lace piece rather than a printed edge, and the cuffs are gathered so they sit at the wrist instead of sliding. Most build a bear workshop pajamas are a loose two-piece; this is cut as one garment, so it stays put on a plush that is carried around.

Will it fit your plush?

Measure your friend from the top of the head to the bottom, sitting or standing as they normally do. It comes in 4 sizes, cut for plush 28cm, 36cm, 47cm and 56cm tall. It is designed around Jellycat proportions and fits other plush of the same height just as well.

Getting it on

Feet in first, then the arms. The body is cut roomy so a soft plush is not squeezed. Nothing here is tight enough to squash a soft plush, and nothing is loose enough to slide off.

Looking after it

Hand wash cool and treat the lace gently; no soaking, no twisting. Lift it out, press between towels and dry flat. A cool iron on the lining side only, if needed.

Made by A Flying Wish

Each piece leaves our workshop finished by hand. We build the pattern around a height range, so one outfit suits several beloved friends. It is made to be dressed and undressed often, and to survive it.